GIGABYTE GN-AP101B - Manual (Page 10)

5
There are two installation mode for your reference as follow
Static IP address
Method 1
If you are Not using a DHCP server in your network, you can configure the AP
by connecting to the computer directly.
1. You will need to assign a Static IP Address to the computer that you are
using to configure the Access Point on the same subnet . For instance, the
default IP address of the Access Point is 192.168.1.1 and the subnet mask
255.255.255.0. You can enter IP address 192.168.1.20 (assuming that it is
not already assigned to another network device), subnet mask
255.255.255.0 to your computer.
2. Connect to the Access Point one by one and assign a static IP to each
Access Point. For example, 192.168.1.2 or 192.168.1.y, etc. (If the IP
address of your network is 10.1.5.x then your Access Point can be
assigned to 10.1.5.y.)
3. Make sure that every Access Point has a unique IP.
4. After all Access Points have been configured successfully, then you can
use AP Manager to control/monitor all Access Points network.
PC (AP Mana ger)
192.168.1.x
DHCP (Disable)
192.168.1.1(default)
GN-AP101B
PC (AP Manager)
192.168.1.x
192.168.1.1
192.168.1.2
192.168.1.y
… … ..