Stovax Avanti PR0651 - Manual (Page 2)

5. For the balanced flue gas Riva 53, 67 and 70 use the
bracket shown in diagram 3B.
6. For the convetional flue gas Riva 53 use the bracket shown
in diagram 3C.
7. For the electric Riva 67 use the bracket shown in
diagram 3D.
8. Before positioning,the door assembly, check the location of
the securing lugs on the back of the door assembly. These
are at the top of the sprung loaded hinge. Slot into the
rectangular holes on the backplate. See diagram 4.
4
AR0992
3D
AR1186
3C
AR1218
3B
AR0990b 9. Carefully lift the door assembly into the open position and
secure the bottom of the spring mechanism with fixing
screws. See diagram 5.
10. Close the door and check positioning. Always lift the door
from both the right and left hand side as shown in diagram 6.
11. Instruct the user on the correct way to lift the door.
1. Continue with the commissioning tests detailed in the
Installation Instructions supplied with the appliance.
2. Ensure that the supplementary sheet is attached to the
Installation Instructions and leave with the user.
FIXING KIT COMPONENTS
COMP. NO. DESCRIPTION QUANT’Y
GZ 3863 Balanced Flue bracket / pair 2
GZ 3734 B Vent bracket 2
GZ4215 Riva 53 Avanti FR FIX BRTs 2
FA 0042 No. x 1 Black washer HD Pozi-
drive
2
FA 0016 No. 8 x 10 Black Pozi-drive 4
PR 0651 Assembly Instructions 1
COMMISSIONING
6
AR1190
5
AR0993
USER INSTRUCTIONS
To access the fire’s controls:
• Gently pull the frame forwards and swing up.
Always lift the door from both the right and left hand side
as shown in diagram 6 below.
The controls are situated at the bottom right of the appliance. The
batteries, if applicable, are beside the control box.
Batteries for Gas versions
Details on Replacing the Batteries are given in the User section of
the appropriate Riva Instructions manual.
1. Only clean the frame when it is cold.
2. The stainless steel should be cleaned using Stovax Stainless
Steel Cleaner Part Number 5035 which is available from
your local Gazco/Stovax stockists.
3. The black steel should be wiped with a damp cloth and
buffed with a lint-free duster.
CLEANING THE FRAME
CONTROLS & BATTERIES
INSTALLATION
INSTRUCTIONS
Covering the following frames:
8642BS Riva 53 Horizontal Curve 8632BS Riva 53 Vertical Curve
8631BS Riva 67 Standard (Flat) 8633BS Riva 70 Standard (Flat)
8641BS Riva 67 Curved
8643BS Riva 70 Curved
1. Take notice of the locating lugs situated at the top of the
fire as these secure the backplate of the fire. See diagram 1
2. Place the backplate over the locating lugs and fully engage
to ensure secure fixing.
Important:
Ensure all three lugs have engaged. See
diagram 2.
3. Secure the lower part of the frame using the appropriate
brackets supplied.
4. Coventional flue gas Riva 67 use the bracket shown in
diagram 3A.
3A
AR0990
2
AR0989
1
AR0988
FITTING
1 2