Gefen GTB-HD-SIGGEN - Manual (Page 52)

46
HD PATTERN SIGNAL GENERATOR SOFTWARE
After the HD Pattern Signal Generator is launched, the following screen will be
displayed:
2. Select the COM port from the pull-down list. COM port 1 is selected by
default.
3. Click the Connect button to initialize the connection between the software
and the HD Pattern Signal Generator.
If you are unable to connect to the HD Pattern Signal Generator, make sure that
the correct COM port is selected in the software. The Disconnect button will turn
red if the connection between the software and the HD Pattern Signal Generator
cannot be established.
The Connect button will
turn green to indicate a
successful connection
The Disconnect button
will turn red to indicate
no connection.
Selects the COM port