Banks Power Ford Trucks: (Gas ’87 - 97 7.5L EFI) Power Systems- Stinger system '87-96 SC, EC & CC (For Use w_ 460 EFI Engine) - Manual (Page 3)

banks stinger ® systeM
ford 460 efi truck
dear customer:
your new banks stinger is a unique combination of air intake
and exhaust components designed to make the most of your
engine’s power potential. by removing intake and exhaust
restrictions, providing cooler intake air, and tuning the exhaust
to create a scavenging effect, your engine can produce more
power at a higher level of efficiency. if your driving habits
remain the same, your fuel mileage should go up, and you can
run on the same octane fuel you are accustomed to using.
if you have any questions concerning the installation of the
banks powerpack
® kit, please call gale banks engineering at
(626) 969-9600 between 8:00 am & 5:00 pm (pt) and ask for the
service department.
thank you.
3 p.n. 96346 V.2.0
generaL instaLLation practices
for ease of installation and trouble-free
operation of your banks stinger ® system,
please read this entire 8-page owner’s manual
before starting any work. (if any pages are missing
from this package, please call gaLe banks
engineering immediately for a replacement.)
become thoroughly familiar with all components
& phases of the installation & determine what
additional tools or materials you may need to
complete the installation.
any time the vehicle is raised off its wheels,
it should be supported by jack stands or
ramps of adequate capacity for the vehicle’s
weight. neVer perforM any Work under a
VeHicLe supported onLy by its serVice jack or a
HydrauLic jack.
NotificatioN
the Banks Ram-air filter comes pre-oiled and no
oiling is necessary for initial installation. Service
the filter as specified in the cleaning and oiling the
Banks Ram-air filter Section of this manual.
1.
2.