GE Spacemaker WSM2400L - Manual (Page 7)

How to your dryer
reduce the risk of fire, electric shock, or injury to persons,
read the INSTRUCTIONS before operating this appliance.
the dryer properly
●
Load sorted clothes into dryer.
See page 5.
●
Clean lint filter before each load.
Remove the lint filter by pulling
straight out. Wipe all accumulated
lint from screen. Occasionally
wash filter using soap and warm
water. Rub lightly, rinse and dry
thoroughly. This
help remove
all fabric softener buildup.
Do not use dryer-applied fabric
softeners unless you follow these
lint cleaning instructions.
Do not operate dryer without lint
filter in place.
●
Close door. Door must be closed
before dryer will operate.
timed dry. HIGH
delicate
... NO HEAT
o
temperature push to start dryer
Q
Set the
See Controls Setting Guide on
pages and 9.
Selector clockwise
to desired cycle and select correct
drying time for load type.
Start button.
(Opening door during operation
stops dryer. To
close door
and press Push to Start button again. )
Buzzer sounds briefly to alert You
when cycle is
-
Dryness Selections Guide for the Automatic Cycle
to
Middle
●
For most normal loads.
.
Set toward
MORE DRY
● For loads that include heavyweight fabrics.
●
If you desire to remove more moisture.
Set toward
LESS DRY
● For lightweight fabric loads.
--
F
● For very small loads. (Add two or more similar
articles, even if dry, to assist tumbling. )
● If you desire to remove less moisture.
&
Drying
. not overload—Garments
being dried or should
tumble freely.
●
Remove
To help prevent remove
from the dryer immediately at the
end of the drying cycles.
●
Place on hangers-Permanent
Press and Polyester garments
look best if placed on hangers after
drying.
How and Automatic
Drying Differ
Automatic drying-The Automatic
Dry Control system continually
senses air temperature in dryer
drum. Wet laundry keeps this air
cool. When drum air is warm
enough, heat turns off. When the
air cools, heat turns back on. This
on and off cycling may happen a
number of times (depending on the
fabric, load size and Cycle Selector
setting).
Cycle advances
(when the heat is until it
automatically turns dryer off.
Timed drying—You select the
number of minutes you wish the
dryer to run and it turns off at
the end of this time period.
7