Great Dane Scamper HG GDB10025 - Manual (Page 4)

Safety - 1
SAFETY
Safety
Understanding The Machine Safety Labels
Safety-Alert Symbol
The machine safety labels shown in this section are placed
in important areas on your machine to draw attention to
potential safety hazards.
On your machine safety labels, the words DANGER,
WARNING, and CAUTION are used with this safety-alert
symbol. DANGER identifies the most serious hazards.
The operator’s manual also explains any potential safety
hazards whenever necessary in special safety messages
that are identified with the word, CAUTION, and the safety-
alert symbol.
DANGER/POISON
MX9292 MX9261
• Shield eyes, explosive gases can cause blindness or
injury.
• No sparks, flames, smoking.
• Sulfuric acid can cause blindness or severe burns.
• Flush eyes immediately with water, get medical help
fast.
• Keep out of the reach of children.
• Do not tip.
• Keep vent caps tight and level.
CAUTION
MX9295 M9261
• This product is designed for professional and
commercial users.
• Operation training is required.
• Carefully read safety instructions.
• Know function of controls before operating.
• Practice with cutter blades off until confident.
• Clear mowing area of all debris.
• Keep all guards, covers and shields in place while
working.
• Do not disable or bypass any safety device.
• Always wear safety goggles while operating.
• Always park machine on level surface.
• Avoid contact with cutter blades. They may be rotating.
• Keep children and others clear from area.
• Set ground speed control to safe speed.
• Slowly and smoothly move speed control levers to start
and stop machine.
• Reduce speed and avoid sharp turns.
• Always hold on to safety bar while operating.
• Be careful on slopes, do not mow where stability or
traction is in doubt.
• To obtain additional operator manual and safety
instructions, contact Great Dane dealer or write to: Great
Dane Power Equipment, P.O. Box 33009, Raleigh, NC
27636-3009, USA.