Gemini UZ-1128 - Manual (Page 6)

(6) (6) (6) (6) (6)
CONNECTING THE RECEIVER TO POWER:
Plug the antennas into the TNC socket on the receiver, if the antennas
are detachable. Point the antennas upward. Check that the voltage of
the supplied AC adapter conforms to the voltage available (AC110 or
AC220) in local area. Using the wrong AC adapter may cause irreparable
damage to the unit. Plug the feeder cable of the supplied AC adapter
into DC IN socket on the receiver. Then plug the AC adapter into a
power outlet.
TO A RECEIVER TO AN AUDIO MIXER OR
AN AMPLIFIER:
When using a standard audio cable with 3-pin XLR connectors or 1/8th”
phone plugs to plug into the MIC IN on the audio mixer or on the
amplifier, please push the Volume Button on the receiver to 20 (approx.) ,
the output level for balanced and unbalanced output is around at 77mV.
When using a standard audio cable with 3-pin XLR connectors or 1/8th”
phone plugs to plug into the LINE IN on the audio mixer or on the
amplifier, please push the Volume Button on the receiver to 32, the
output level for unbalanced and balanced output is about at 770mV.
Never use the balanced and unbalanced audio outputs at the same time!
This may cause signal loss or increased noise.
INSERTING BATTERIES INTO THE HANDHELD /
BODYPACK TRANSMITTER:
Open the battery cover and insert batteries into the battery compartment
conforming to the polarity (+)(-) marks. The transmitter can not work with
incorrectly inserted batteries. When push the ON/OFF switch to “ON” to
switch the power on, LCD shows battery power level. If it displays
insufficient power, the inserted rechargeable batteries can be charged
by using the supplied DC 1.5 plug cable directly connection to DC Out
on the receiver and charging input on the transmitter. It should take up to
10 hours for charging. Close the battery cover.
SETTING UP THE HANDHELD MICROPHONE TRANSMITTER:
Switch the receiver power on and check the frequency and volume level.
Switch the transmitter and hi-fi appliance (amplifier, tape deck etc.) power on.
Test the microphone and adjust the levels on your audio mixer or amplifier.
SETTING UP THE BODYPACK TRANSMITTER
A. CONNECTING A MICROPHONE:
Open the battery cover. Push the MIC/LINE switch to “MIC” and use the
supplied screwdriver to adjust the GAIN at appropriate position.
Plug the 3-pin mini XLR connector end of the microphone cable into the
audio input connector on the bodypack transmitter. Switch the transmitter
and hi-fi appliance (amplifier, tape deck etc.) power on. Test the
microphone and adjust the levels on your audio mixer or amplifier.
B. CONNECTING AN INSTRUMENT:
Open the battery cover. Push the MIC/LINE switch to “LINE” and use the
supplied screwdriver to adjust the GAIN at appropriate position.
Plug the 1/4th” phone plug of the optional guitar cable to the output jack
on the instrument and the 3-pin mini XLR into audio input connector on
the bodypack transmitter. Switch the transmitter and hi-fi appliance (amplifier,
tape deck etc.) power on. Play the instrument for testing and adjust
the levels on your audio mixer or amplifier.
TROUBLE-SHOOTING:
NO SOUND:
Check the power supply of the microphone and receiver.
Check that the transmitter and receiver are tuned to the same frequency.
Check whether the hi-fi appliance is switched on and the receiver output
is connected to mixer or amplifier input.
Check whether transmitter is too far away from receiver or SQUELCH
control set too high.
Check whether receiver is located too near metal object or there are
obstructions between transmitter and receiver.
SOUND INTERFERENCE:
Check the antenna location.
When using 2 or above microphone sets simultaneously, make sure
that the chosen frequencies are not interfered.
Check whether the interference comes from other wireless microphones,
TV, radio and etc.
DISTORTION:
Check the volume level of the receiver is set too high or too low.
Check whether the interference comes from other wireless microphones,
TV, radio and etc.
SPECIFICA SPECIFICA SPECIFICA SPECIFICA SPECIFICATIONS: TIONS: TIONS: TIONS: TIONS:
RECEIVERS: RECEIVERS: RECEIVERS: RECEIVERS: RECEIVERS:
UZ-1128:
UZ-1128: UZ-1128: UZ-1128: UZ-1128:
Frequency range....................................................................................USA-740-770MHz = 700CH
.........................Europe A-France/Spain: 740-770MHz = 700CH B-UK/Germany: 840 - 870MHz = 700CH
Case.....................................................................................................................Half 19" EIA Case
Receiving System...................................................................................................PLL synthesized
Receiving Mode.........................................................................Single Channel, Switching diversity
Frequency Stability............................................................................................................+/- 0.05%
Receiving Sensitivity..........................................................................At 8 dBuV over 80dB S/N ratio
Image & Spurious Rej...............................................................................................80 dB minimum
Selectivity..............................................................................................................................> 50dB
Modulation Mode.........................................................................................................................FM
IF Frequency............................................................................................1st: 56MHz 2nd: 10.7MHz
Dynamic Range......................................................................................................................>96dB
Tone Signal.....................................................................................................................32.768KHz
S/N Response........................................Over 94dB, at 48KHz deviation and 60dBuV antenna input
AF Response................................................................................................50Hz to 15KHz(+/-3dB)
T.H.D. ........................................................................................................................<1%(at 1KHz)
Power Supply................................................................................................................DC 12 ~ 18V
Audio Output.....................................................................................Balanced & unbalanced output
Current Consumption..............................................................................................260mA +/- 10mA
Dimension(mm)WxHxD..............................................................................................210 x 44 x 165
UZ-9128: UZ-9128: UZ-9128: UZ-9128: UZ-9128:
Frequency range.................................................................................USA: 740 - 770MHz = 700CH
......................Europe A-France/Spain: 740 - 770MHz = 700CH B-UK/Germany: 840 - 870MHz = 700CH
Case...................................................................................................................19" EIA Metal Case
Receiving System...................................................................................................PLL synthesized
Receiving Mode.................................................................................Single Channel, True-diversity
Frequency Stability............................................................................................................+/- 0.05%
Receiving Sensitivity..........................................................................At 8 dBuV over 80dB S/N ratio
Image & Spurious Rej...............................................................................................80 dB minimum
Selectivity..............................................................................................................................> 50dB
Modulation Mode.........................................................................................................................FM
IF Frequency............................................................................................1st: 56MHz 2nd: 10.7MHz
Dynamic Range......................................................................................................................>96dB
Tone Signal.....................................................................................................................32.768KHz
S/N Response........................................Over 94dB, at 48KHz deviation and 60dBuV antenna input
AF Response................................................................................................50Hz to 15KHz(+/-3dB)
T.H.D..........................................................................................................................<1%(at 1KHz)
Power Supply................................................................................................................DC 12 ~ 18V
Audio Output.....................................................................................Balanced & unbalanced output
Current Consumption..............................................................................................300mA +/- 10mA
Dimension(mm)WxHxD..............................................................................................420 x 45 x 180
ZM-128: ZM-128: ZM-128: ZM-128: ZM-128:
Mic Type.........................................................................................................Handheld microphone
Frequency range.................................................................................USA: 740 - 770MHz = 700CH
.....................Europe: A-France/Spain: 740 - 770MHz = 700CH B-UK/Germany: 840 - 870MHz = 700CH
RF Power Output..........................................................................................................10mW(max.)
Oscillation Mode.....................................................................................................PLL synthesized
Frequency Stability..........................................................................................................+/- 0.005%
Maximum Deviation.....................................................................+/-48KHz with limiting compressor
Spurious Emission............................................................................>60 dB below carrier frequency
T.H.D..........................................................................................................................<1%(at 1KHz)
Chargeable Battery.......................................................................DC 3V(1.5v x 2 AA size batteries)
Tone Key.........................................................................................................................32.768KHz
Mic Unit.................................................................................................Uni-directional dynamic unit
LED Indicator...................................................................................Power ON-OFF and low battery
Current Consumption.......................................................................................................65 +/- 5mA
Dimension(mm)WxHxD.......................................................................................................266 x 55
ZB-128 ZB-128 ZB-128 ZB-128 ZB-128
Mic Type.....................................................................................Bodypack transmitter
Frequency range....................................................................USA: 740 – 770MHz = 700CH
.................Europe:A-France/Spain: 740 - 770MHz = 700CH B-UK/Germany: 840 - 870MHz = 700CH
RF Power Output........................................................................................10mW(max.)
Oscillation Mode....................................................................................PLL synthesized
Frequency Stability.............................................................................................+/- 0.005%
Maximum Deviation.................................................................+/-48KHz with limiting compressor
Spurious Emission...............................................................>60 dB below carrier frequency
T.H.D......................................................................................................................<1%(at 1KHz)
Chargeable Battery.........................................................DC 3V(1.5V x 2 AA size batteries)
Tone Key.......................................................................................................32.768KHz
Mic Unit...........................................................................Uni-directional condenser unit
LED Indicator..........................................................................Power ON-OFF and low battery
Current Consumption.....................................................................................65 +/- 5mA
Dimension(mm)WxHxD.............................................................................65 x 100 x 27
DESIGN & SPECIFICA DESIGN & SPECIFICA DESIGN & SPECIFICA DESIGN & SPECIFICA DESIGN & SPECIFICATIONS SUBJECT T TIONS SUBJECT T TIONS SUBJECT T TIONS SUBJECT T TIONS SUBJECT TO CHANGE WITHOUT NO O CHANGE WITHOUT NO O CHANGE WITHOUT NO O CHANGE WITHOUT NO O CHANGE WITHOUT NOTICE. TICE. TICE. TICE. TICE.