Global Machinery Company BHT500 - Manual (Page 8)

Operating the hedge trimmer
WARNING. Do not use the hedge trimmer in the rain or
store the hedge trimmer in wet conditions.
WARNING. If cordset is cut or damaged remove it
emmediately from the power point.
This product requires the use of two hands to ensure
safe operation.
Inspect the area to be cut before starting. Remove any
objects or debris that could be thrown, jammed or
become entangled in the blades.
Adopt a stable stance always keeping the Hedge Trimmer
in front of your body. Grip the front handle bar switch
with one hand. With the other hand grip the rear handle
and with your fingers squeeze the trigger switch.
Allow the cutting blades to reach full speed before
commencing the cut.
When cutting always move in a forward direction and
never backwards, you could fall over unseen obstacles.
Never work towards people or solid objects such as walls,
trees or vehicles etc.
If during cutting the blade stalls, stop the Hedge Trimmer
immediately and disconnect it from the mains supply
before investigating the cause.
Remove any jammed debris from the blades and examine
them for any damage before re-commencing cutting.
Always replace any damaged blades.
Shaping
1. Trim a hedge so that it is wider
at the bottom than the top.
2. This improves light
penetration and promotes
healthy growth.
3. Narrow the hedge
approximately 100mm for
every metre in height.
4. A bush can be round or
column shaped.
Cutting
1. Assume a secure position,
using two hands to
hold the trimmer and
switch on.
2. Trim both sides of the
hedge, starting at the
bottom. This prevents
cuttings falling into the
area yet to be cut.
3. Pass the blade lightly through the surface of the hedge.
Do not attempt to cut too deep.
4. Trim the top of the hedge.
5. For older hedges that require cutting back substantially,
use pruning shears to cut the thicker branches and
then finish the job with the hedge trimmer.
WARNING. Do not let the blade come into contact with
fencing wire or any other object that could damage it.
Pruning
Your hedge trimmer is
versatile. It can also be used
for trimming back new growth
from small shrubs onto the
driveway or into the garden.
Lubrication
WARNING. Always ensure that the trimmer is switched
off and the plug is removed from the power point before
making any adjustments.
1. After each use, clean the blades and lightly lubricate
with general purpose oil or spray lubricant.
8