GE RM24941 - Manual (Page 5)

Code Entry
In order for the RM24941 to control your devices (TV, VCR, DVD, etc.), you must program
it with the library code for each device. This enables the RM24941 remote to control your
device with the proper commands. If your TV, VCR, DVD, or satellite receiver is an RCA,
ProScan or GE brand, the RM24941 may not need any programming to control them. To
program the remote with the codes for your devices, you can use one of three methods:
Library Code Entry, Code Search or Code Autosearch.
Library Code Entry
You can enter codes in your RM24941 from the Code List using the SETUP key on the rub-
ber keypad. When you enter a valid code for any given mode (e.g., when you enter a code
for a TV), the Default Key Label Screen is used and any previously Learned functions for
that mode are deleted. The mode is reset to its power-on default state.
To enter a code directly from the Code List, follow these steps:
1. Manually turn on the device to be controlled (TV, VCR, DVD, etc.).
2. Press and hold the SETUP key on the rubber keypad until the LED
indicator light remains on and the touchscreen shows the Main Setup
Screen. This process takes approximately 2-3 seconds.
3. Release the SETUP key.
4. Press and release the LCD CODE key. The LED indicator light blinks
once to indicate acceptance of the keypress.
5. The touchscreen now shows the Device Setup Screen. Press and release
the device key on the rubber keypad for the device whose code you
want to enter (TV, VCR, SAT/CBL, etc.). The LED indicator light blinks
once to indicate acceptance of the keypress.
6. For AUX1 or AUX2, press and release the AUX device key, followed by
the desired device key to be programmed under AUX (TV, VCR,
SAT/CBL
, etc.).
3
24941manual 8/13/03 8/19/03 8:42 AM Page 5