Graco Latch EZ - Manual (Page 6)

Tighten EZ LATCH ™ by pushing down hard
on car seat and pulling the adjustment belt
(Fig. d).
Test car seat for secure installation as
described in car seat instruction manual by
pulling front-to-back and left-to-right.
Check that the EZ LATCH ™ stays tight and
does not slip from the tightened position.
If it does not stay tight, try another seating
position or contact Customer Service.
For forward-facing car seats only, attach the
top tether strap and tighten top tether strap.
Forward-facing car seats SHOULD use a top
tether strap in addition to EZ LATCH ™ .
If you do not have a top tether strap, call
1-888-224-6549 with your model number
and date of manufacture to see if a top tether
strap is available for your model.
Each trip check that car seat is securely
installed; tighten if necessary.
❃
Installing Car Seat In Vehicle
Follow instruction manual provided with
car seat for installation in vehicle; use the
EZ LATCH
™ in place of the vehicle seat belt.
For ease of installation, extend EZ LATCH ™
to its maximum length.
Position car seat, rear-facing or
forward-facing, correctly for your child
(Fig. a or Fig. b).
IMPORTANT: Release Buttons must face up
and Adjuster must face outward so belt can
be adjusted without interference (Fig. a).
Thread EZ LATCH ™ through car seat belt
path normally used for vehicle seat belt, as
shown in car seat manual.
Belt must lay flat and not be twisted.
Hook Connectors to vehicle lower anchors.
Pull firmly on Connectors to be sure they are
attached (Fig. c).
5
1
2
4
5
6
7
8
3