Grizzly Model G0536 - Manual (Page 8)

-6- G0536 Scroll Saw
Amperage Draw
The Model G0536 motor is wired to operate at
110V and draw the following load:
Motor Load ..........................................1.4 Amps
Plug Type
The Model G0536 is supplied with a NEMA 5-15
plug. DO NOT modify the plug or power cord in
any way. See
Figure 1 for a NEMA 5-15 plug and
grounded outlet.
Circuit Breaker Requirements
Use the following guidelines when choosing a cir-
cuit breaker for your machine:
Recommended Circuit Breaker ..............5 Amp
Your Circuit Capacity
Always check to see if the wires in your circuit are
capable of handling the amperage load from your
machine. If you are unsure, consult a qualified
electrician.
If you operate this machine on any circuit that is
already close to its capacity, it might blow a fuse
or trip a circuit breaker. However, if an unusual
load does not exist and a power failure still
occurs, contact a qualified electrician or our
Service Department at (570) 546-9663.
Serious personal injury could occur if you
connect your machine to the power source
before you have completed the assembly
process. DO NOT connect the machine to
the power source until instructed to do so.
Figure 1. NEMA 5-15 plug and
grounded outlet.
110 Volt
SECTION 3: CIRCUIT REQUIREMENTS