General Tire 15-220 - Manual (Page 10)

10
SELECTION GUIDE FOR TABLE INSERTS
This machine is supplied with 5 spindles, and four table
inserts. The spindle diameters range from 1/4" to 2".
When changing spindles, the table insert will need to
be changed to the matching size. Each plate has
notch (
) to fit the alignment pin ( ) in the table to
ensure that it is properly fitted and installed in the table
opening.
There are 2 insert plates with oblong openings and 2
with round openings. The oblong insert plates are
used when the table is tilted for bevel sanding.
The following chart explains which inserts can be used for different diameter spindles.
FAILURE TO USE THE PROPER INSERT WITH THE CORRESPONDING SPINDLE MAY RESULT IN INJURY AND/OR DAMAGE TO
THE MACHINE OR THE WORKPIECE.
SPINDLE DIAMETER TABLE INSERT (OPENING SHAPE/SIZE)
1/4” . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#86 (ROUND) & #87 (OBLONG) -SMALL
1/2” . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#86 (ROUND) & #87 (OBLONG) -SMALL
5/8” . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#86 (ROUND) & #87 (OBLONG) -SMALL
1-1/2” . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#85 (ROUND) & #84 (OBLONG) -LARGE
2” . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#85 (ROUND) & #84 (OBLONG) -LARGE
RECOMMENDED ADJUSTMENTS
Step 1
Loosen both locking levers, position the table at 0° and
re-tighten the locking levers.
Step 2
With a spindle installed, place a square on the table.
Rest the long section of the square against the
sanding spindle. The square should be flat against
the table and the spindle from all four sides.
SETUP FOR 90º SANDING