Grizzly Industrial Inc.Straight Handle Metal Shear G8120 - Manual

Introduction
This straight handle metal shear is highly maneu-
verable for working into tight spots. It cuts sheet
steel up to
3 ⁄
64
" thick and sheet aluminum up to
1 ⁄
16
" thick. Width of cut is 7 ⁄
32
". The no-load speed
is 2500 strokes per minute and average air con-
sumption is 6 CFM.
Inventory
A. Metal Shear ................................................ 1
B. Hex Wrench 4mm ...................................... 1
Operation
Install a 1 ⁄
4
" NPT quick connect air fitting into the
end of the metal shear. Lubricate before use with
pneumatic tool oil, then connect metal shear to
your regulated air source. Pull the handle lever to
operate.
MODEL G8120
STRAIGHT HANDLE
METAL SHEAR
INSTRUCTION SHEET
Figure 1. Model G8120.
Figure 2. Lubricating directly into air fitting.
COPYRIGHT © SEPTEMBER, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8557 PRINTED IN TAIWAN
Maintenance
Metal shear MUST have 3-4 drops of oil directly
dropped into the air fitting before each use as
shown in
Figure 2.
If blade sharpening is ever needed, remove the
three lock screws (#23) with the 4mm hex wrench
to remove the blades & spacers (#24–27). Take
the blades to a qualified sharpening and grinding
service, then reinstall.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
CUT HAZARD!
Keep hands and fingers
away from scissor action
of blades. Serious cuts will
occur!
DO NOT EXCEED 120 PSI!
Personal injury could
occur.