Griffin Technology Final Vinyl 2.5 - Manual (Page 8)

Recording and Monitoring Audio
You’re ready to start recording with Final Vinyl. You may use any
audio device you choose; here, we use a turntable as an example.
1. Press the Record button; Final Vinyl will start recording. If you
wish to monitor the incoming audio, click the “Playthrough/
Monitor” button. The Playthrough button works whether you
are recording or not.
2. Start your turntable and place the needle on the
record. While recording, the waveform window will
turn red and the Record button will blink. The
elapsed time of your current recording session will
be displayed in the Time/Location indicator.
3. To stop recording, press the flashing Record button
again. Final Vinyl will then calculate and draw the
waveform, a visual representation of your audio
signal. The longer the recording, the longer the
calculation will take, so be patient!
4. If you wish to record both sides of an album as one
continuous file, after the first side has finished, press
Final Vinyl’s Record button to stop recording. Turn
the record over, press the Record button, and start
the turntable again. Final Vinyl will automatically
continue recording where the other side left off.