Genie TML-4000N - Manual (Page 16)

14 Genie TML-4000 and TML-4000N Part No. 97600
Operator's Manual Third Edition • Second Printing
FUNCTION TESTS
Setup
1 Position the machine at the desired work site.
2 Disconnect the trailer lights and safety chains.
3 Open the latch on the coupler.
4 Pull the release pin on the tongue outrigger and
rotate the outrigger towards the ground until the
outrigger pin locks securely in place.
5 Turn the jack handle to lower the outrigger foot
pad and raise the tongue of the machine
enough to clear the tow vehicle.
6 Release the spring pin on the side outriggers
and lower them to the ground. Make sure the
locking arms are locked in place.
7 Turn the outrigger jack handles to level the
machine. Level the machine using only the
leveling jacks.
Install the Lamp Fixtures (if
applicable)
For each lamp fixture:
8 Remove the lamp fixture from the storage
location under the covers.
9 Slide the fixture into the holes on the mounting
bracket and close the latches.
10 Insert and close the safety pins.
11 Remove the cap from the receptacle socket and
connect the electrical plug.
Note: Make sure the safety pins are properly
installed before raising the mast.
Test the Machine Functions
By raising and extending, then retracting and
lowering the mast back to the horizontal position,
the following functions will be tested: winches,
latches, mast extension and mast rotation.
12 Unlock the mast hold-down latch.
13 Turn the raise/lower winch handle clockwise until
the mast raises approximately 2 feet /
60 cm.
Result: A clicking sound should be heard as the
winch handle is turned.
14 Release the winch handle.
Result: The winch brake should hold when the
handle is released.
15 Continue to turn the winch handle clockwise
until the mast reaches full vertical position.
Result: The mast should raise smoothly, free of
hesitation or binding.
Result: The spring latch on the front of the
machine should lock the mast securely into
place.
16 Turn the extend/retract winch handle clockwise
until the mast extends approximately 2 feet /
60 cm.
Result: A clicking sound should be heard as the
winch handle is turned.
Result: The mast sections should telescope
smoothly, free of hesitation or binding.
17 Release the winch handle.
Result: The winch brake should hold when the
handle is released.