GSI Outdoors PNEG-1597 - Manual (Page 13)

3. Assembly
PNEG-1597 Sweep Tractor Assembly Instructions 13
4. Slide the tractor axle (shaft) through the left side of the pillow block bearing and the lock collars so
as to pass through the right side of the pillow block bearing. Make sure the keyway is on the left
hand side.
NOTE: Do not tighten lock collars.
5. Assemble the 40 tooth sprocket to the tractor axle (shaft) using square key (3/8" x 1-3/4" long).
6. Mount the wheel hub to the tractor axle (shaft) using 3/8"-16 x 2-1/2" hex head cap screw and
3/8"-16 stover lock nut.
Figure 3B
NOTE: Left Hand and Right Hand is determined
from the BACK of the tractor frame throughout
the manual.
40 Tooth sprocket
Left Hand
3/8" x 1-3/4" Square key
3/8"-16 x 2-1/2"
Hex head cap screw
3/8"-16 Stover lock nut
NOTE: Lock collars on inside of frame.
Back