GE Monogram ZBD3000 - Manual (Page 21)

QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM POSSIBLE CAUSE
CONTROL PANEL too long between touching of selected pads. Each pad must be touched within
LIGHTS GO 30 seconds of the others. To relight, any pad again, or unlock and door.
WHEN YOU’RE
SETTING CONTROLS
DISHWASHER A fuse your home maybe blown, or circuit breaker tripped. Replace fuse or
WON’T RUN reset circuit breaker. Remove any other appliances from the circuit.
UNUSUAL NOISE Utensils may not be secure on rack pins, or something may have dropped from
the rack. Water is causing utensils to rattle. Make sure everything is securely placed
in dishwasher.
Water draining out of tub immediately after you touch CLEAR pad. The
sounds you hear are normal ones.
DISHES DON’T DRY Make sure inlet water temperature is correct. (To test, see to Test Water
Temperature section.)
Unload the bottom rack first. Water dishes in the rack maybe spilling
onto the bottom rack.
Check for improper loading. Dishes shouldn’t nest together. Avoid overloading.
Check rinse agent dispenser see that it’s not empty.
UNCLEAN DISHES Check inlet water temperature. It should be at least (To test, see How
FLATWARE Test Water Temperature section.)
Water pressure may be temporarily low. Turn on a faucet. Is water coming out slower
than usual? If so, wait until pressure is normal before using your dishwasher.
Plugged air gap. (See Care and Cleaning section.)
(continued next page)
21