GE 10 DCA - Manual (Page 10)

Consumer Support
Troubleshooting T
ips
Installation Instructions
Care and Cleaning
Operating Instructions
Safety Instructions
10
Installing a J-Model in an existing wall case.
Read these instructions completely and carefully.
GE strongly recommends the removal of the old
wall case and the installation of a new GE Wall
Case. If you decide to keep the existing wall
case, you may need a kit to ensure proper
performance. If you DO NOT use a kit, you
run the risk of poor performance or product
failure. This is not covered under the terms
of the GE warranty.
IMPORTANT!
J-model air conditioners may fit in existing wall
cases. However, they often need a kit to properly
adapt the case to the GE air conditioner. Answer
these questions and see the chart below for the
proper kit.
What brand air conditioner will you be
replacing?
What are the dimensions of the wall case
currently in use?
What is the model number of the chassis
currently in use? What is the model (or Type)
number of the wall case currently in use?
Frequently, the J-model adapter kit will apply
to another brand model “series” or specific
vintage. In these cases, you need the chassis
model number and/or the wall case or “type”
number to confirm the use of the correct
adapter kit.
What type of outdoor grille is used with the
current wall case?
There may be an architectural grille attached
to a wall case to enhance the exterior
appearance of the building. Custom grilles
may be used with J-model wall cases provided
a J-model adapter kit is also used to ensure
proper airflow.
D
C
B
A
J-Model Qualifying Questions