Spreader or riving knife alignment – Grizzly G0690 User Manual

Page 70

Advertising
background image

-68-

Model g0690/g0691 (Mfg. 11/10+)

Spreader or Riving

Knife Alignment

Checking Alignment

the blade guard spreader and riving knife must
be aligned with the blade when installed. if the
spreader/riving knife is not aligned with the blade,
then the workpiece will before forced sideways
during the cut, which will increase the risk of kick-
back.

Tools Needed

Qty

straightedge ...................................................... 1

To check the spreader/riving knife alignment:

1. disCoNNECt thE saW FroM poWEr!

2. raise the saw blade to the maximum height

so you have easy working access.

3. place the straightedge against the top and

bottom of blade and spreader/riving knife,
as shown in

Figure 114. the spreader/riv-

ing knife should be be parallel with the blade
along its length at both positions, and it will
be in the "alignment zone," as shown in

Figure 115.

Figure 115. spreader/riving knife alignment

zone.

6a^\cbZci

OdcZ

HegZVYZgdg

G^k^c\@c^[Z

7aVYZ

— if the spreader/riving knife is not parallel

with the blade and inside the alignment
zone, then it needs to be adjusted. proceed
to

Adjusting Alignment instructions.

— if the spreader/riving knife is not parallel

with the blade at either the top or bottom, it
may be bent.

4. remove the spreader/riving knife and place

it on a flat surface and check to see if the
spreader/riving knife lays evenly along its
length.

— if the spreader/riving knife does not

lay evenly, proceed to

Adjusting Bent

Spreader/Riving Knife on page 69.

Adjusting Alignment

the spreader/riving knife mounting position can
be adjusted into alignment with the blade using
the set screws on the spreader/riving knife mount-
ing block.

possible Tools Needed

Qty

hex Wrench 3mm .............................................. 1
hex Wrench 5mm .............................................. 1

To adjust the spreader/riving knife position:

1. disCoNNECt thE saW FroM poWEr!

2. remove the table insert.

Figure 114. Checking top and bottom riving knife

parallelism with blade.

IVWaZ

Ide6a^\cbZci

7diidb6a^\cbZci

Advertising
This manual is related to the following products: