Working techniques – Garmin TRIOBRAKE 353 User Manual

Page 25

Advertising
background image

WORKING TECHNIQUES

English

25

Make sure that no-one else is in this ”risk zone” before or
during felling.

Felling direction

The aim is to fell the tree in a position where you can limb
and cross-cut the log as easily as possible. You want it to
fall in a location where you can stand and move about
safely.

Once you have decided which way you want the tree to fall
you must judge which way the tree would fall naturally.

Several factors affect this:

Lean of the tree

Bend

Wind direction

Arrangement of branches

Weight of snow

Obstacles within the reach of the tree: for example,
other trees, power lines, roads and buildings.

Look for signs of damage and rot in the stem, this
makes it more probably that the tree will break and
start to fall before you expect it to.

You may find you are forced to let the tree fall in its natural
direction because it is impossible or dangerous to try to
make it fall in the direction you first intended.

Another very important factor, which does not affect the
felling direction but does affect your safety, is to make sure
the tree has no damaged or dead branches that might
break off and hit you during felling.

The main point to avoid is letting the tree fall onto another
tree. It is very dangerous to remove a trapped tree and

there is high accident risk. See instructions under the
heading Freeing a tree that has fallen badly.

Clearing the trunk and preparing your retreat

Delimb the stem up to shoulder height. It is safer to work
from the top down and to have the tree between you and
the saw.

Remove any undergrowth from the base of the tree and
check the area for obstacles (stones, branches, holes,
etc.) so that you have a clear path of retreat when the tree
starts to fall. Your path of retreat should be roughly 135
degrees away from the intended felling direction.

1

Danger zone

2

Retreat path

3

Felling direction

IMPORTANT! During critical felling operations, hearing
protectors should be lifted immediately when sawing is
completed so that sounds and warning signals can be
heard.

1

2

1

2

1

3

Advertising
This manual is related to the following products: