Global Machinery Company REDEYE LSSCR - Manual (Page 13)

13
Maintenance
Warning . Always ensure that the tool is switched off
and the plug is removed from the power point before
making and adjustments or maintenance procedures.
An occasional coat of paste wax on the work table will
allow the wood being cut to glide smoothly across the
work surface.
Oiling the arm bearings
The saws arm bearings should be lubricated after every
50 hours of use. Ensure plug is removed from the mains
power supply.
1. Turn the saw on its side.
2. Squirt a generous amount of SAE 20 oil around the
shaft end and bronze bearings.
3. Let the oil soak in overnight in this position.
4. Next day repeat the above procedure for the opposite
side of the saw.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all
times.
2. Remove dust and dirt regularly. Cleaning is best done
with a brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
Caution. Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the saw.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Repairs
Only an authorised service centre should replace the
cordset or effect other repairs. If the cordset is damaged
or worn, have it repaired or replaced by an authorised
service centre.