GE Monogram ZET1038 - Manual (Page 32)

32
PROBLEM POSSIBLE CAUSE
OVEN WILL NOT • A fuse in your home may be blown or the circuit breaker tripped.
WORK
• The oven controls are not properly set.
• The oven controls are set for cleaning. If necessary, allow the oven to cool
then open the door.
• Make sure the Mode Selector Knob is set to NORMAL.
• If the oven was on during a power outage, turn the Oven Control Knob off,
then back to the desired function to restart the oven.
OVEN LIGHT(S) • The light bulb is loose or defective. Tighten or replace the bulb.
DO NOT WORK
• The oven is self-cleaning or in a “TIMED” delay mode. The oven lights do
not come on during self-cleaning or during a “TIMED” delay mode until
the oven begins heating.
FOOD DOES NOT • The oven controls are improperly set. See the “How to set your oven for
BAKE OR ROAST • baking or roasting” section.
PROPERLY • Oven not preheated for a long enough time (use at least 15 minutes).
• Incorrect cookware or cookware of improper size being used. See the “How
to set your oven for baking or roasting” section.
• Racks in the wrong position. See the “How to set the oven for baking or
roasting” section.
• Use a foil tent to slow down browning during roasting.
FOOD DOES NOT • The oven controls are not set at BROIL. Turn both the Oven Control
BROIL PROPERLY • and Oven Temperature Knob to BROIL.
• Improper rack position being used. See the Broiling Guide.
• Food is being cooked in a hot pan.
• Cookware is not suited for broiling. Use the broiling pan and grid that came
with your oven.
• Aluminum foil used on the broiling pan and grid has not been fitted
properly and slit as recommended.
• In some areas the power (voltage) may be low. Preheat the broil element
for 10 minutes. Broil for the longest period of time recommended in the
Broiling Guide.
OVEN WILL NOT • The oven temperature is too high to set a self-clean operation.
SELF CLEAN Allow the oven to cool to room temperature and reset the controls.
• The controls are not properly set. Be sure the Mode Selector Knob is set in
the TIMED position.
“CRACKING” OR • This is normal. This is the sound of the metal heating and cooling
“POPPING” SOUND during both the cooking and cleaning functions.
DURING CLEANING
EXCESSIVE SMOKING • Excessive soil. Turn the Oven Control Knobs to OFF. Open the
OCCURS DURING • windows to rid the room of smoke. Wait until the locked door
CLEANING • indicator light goes off. Wipe up excess soil and reset the clean cycle.
OVEN NOT CLEAN • The oven was heavily soiled. Clean up heavy spillovers before starting
AFTER A CLEAN the clean cycle. Heavily soiled ovens may need to self-clean again.
CYCLE • Oven is connected to a 208V electrical supply. Set your cleaning
time for 4 hours.
• The oven controls are not properly set. Be sure the Mode Selector
Knob is set in the TIMED position. See the “Self-Cleaning” section.
OVEN RACKS ARE • The racks were cleaned in a self-clean cycle. Apply a small amount of
DIFFICULT TO SLIDE vegetable oil to a paper towel and wipe the edges of the oven racks with the
paper towel. Do not spray with Pam
® or other lubricant sprays.
The Problem Solver
Wall Oven
Questions?
Use this
problem
solver!