Gateway FPD1976W - Manual (Page 15)

www.gateway.com
11
6 Turn on the speaker bar by rotating the power/volume knob clockwise.
Starting the monitor
To start the monitor:
1 Press the power button on the front of monitor. The power LED on the power button turns
on.
2 Turn on your computer.
After your computer is running, the power LED on the monitor’s power button should be
blue. Allow about 10 seconds for the display image to appear. If the power LED is not blue
or you do not see a display image, check the connections. For more troubleshooting
information, see
“Troubleshooting” on page 18 .
3 Adjust the tilt of the monitor for the best viewing angle.
Important
The appearance of your monitor may vary from that shown.
Important
When adjusting the monitor settings, always press the Auto button before
entering the OSD. This will automatically adjust the display image to the ideal
settings for the current screen resolution.