GE WSM2780R - Manual (Page 9)

WARNING-To reduce the risk of fire, electric shock, or injury to persons,
read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
30--50-
Timed
0 HIGH
Load the dryer properly
●
Load sorted clothes into dryer. See Loading section.
●
Clean lint filter before each load. .-..
Remove the lint filter by pulling
G
straight up. Wipe all accumulated
lint from screen. Properly reposition
lint filter after cleaning. Occasionally
wash filter using soap and warm water.
Rub lightly, rinse and dry thoroughly. This
will help remove all fabric softener buildup.
Polyester Knits & Press Drying Tips
Set the controls
See the Controls Setting Guide.
Turn Cycle Selector clockwise to desired cycle
and select correct drying time for load type.
Press the Start button. (Opening door
during operation stops dryer. Tore-start,
close door and press the Start button again.)
Do not use dryer-applied fabric softeners unless
you follow these lint cleaning instructions.
Do not operate dryer without lint filter in place.
●
Close door. Door must be closed before
will operate.
●
Do not overload—Garments being dried or
●
on hangers—Permanent Press and
should tumble freely. Polyester garments look best if placed
●
Remove clothes immediately—To help prevent
on hangers after drying.
remove clothes from the dryer
immediately at the end of the drying cycles,
How Timed and Automatic Drying Differ
Automatic drying—The Automatic Dry Control
system continually senses air temperature in dryer
drum. Wet laundry keeps this air cool. When drum air
is warm enough, heat turns off. When the air cools,
heat turns back on. This on and off cycling may
happen a number of times (depending on the fabric,
load size and Cycle Selector setting). The Cycle
Selector advances (when the heat is
until
it automatically turns dryer off.
Timed drying—You the number of minutes
you wish the dryer to run and it turns off at the end
of this time period.
Dryness Guide for the Automatic Cycle
. For most loads.
Set . loads that include heavyweight
MORE
Auto
fabrics.
. If you desire
remove more
~\
moisture.
Set . For most normal loads.
LESS DRY
.
For very small loads. (Add two
more even if
●
If you to remove moisture.
9