Gianni Industries GEM PSB series - Manual (Page 2)

The product is warranted against defects in material and
workmanship while used in normal service for a period of 1
year from the date of sale to the original customer. The GEM
policy is one of continual development and improvement;
therefore GEM reserves the right to change specifications
without notice.
Warranty
GIANNI INDUSTRIES, INC.
The products are manufactured under an ISO
9 0 0 1
Q C 0 8 0 0 0 0 C e r t i f i e d Q u a l i t y
Management Program environment back its
product quality, performance and commitment
to customer satisfaction.
&
PSB series
Power Supply Unit
Application
1 2 3 4 5 6 7 8 9 0 *
#
Reader
(outdoor)
Lock
Device
Door
Loop
Push
Bar
Uninterruptible
Power
Supply
1.Status LED specifications
- Power:
Yellow: Both AC input and DC outputs are at normal status.
Green: There is no AC input, and the power is supplied by
the batteries.
Red: There is no output voltage.
- Charge:
Red light on: The batteries are charging.
Red light off: The batteries are finished charging. (If the light
is off immediately after the power is on, there may
be some damages with the batteries).
2.Installation specifications
- There is always voltage output between the OUTPUT 1~2.
When the TAMPER is at N.C, there is voltage output between
the OUTPUT 3~5, and when the TAMPER is at N.O, there is
no voltage output.
- Each OUTPUT is protected by individual PPTC from over
current; therefore each load of output may not exceed 1AMP.
- TAMPER switch: system on-off push switch mounted on
outside cover. When outside cover is close, TAMPER switch
is on N.C; when outside cover is open, TAMPER switch is on N.O.
For series connection at ''L'', it will disconnect the main power
for 230Vac.
For parallel connection at the TAMPER, it will control the output
between the OUTPUT 3~5.
F U S E
Main Input
Main Input
OR
TRANSFORMER
TAMPER SWITCH
(option)
(PSB-5A)
PSB-TAMPER
Tamper Switch
When housing case is opened, the tamper switch
PSB3A-2A-115
PSB3A-2A-230
Optional Accessories
To switch DC output
screw fastened:
No. 13, Zhong Sing Road, Tu-Cheng Industrial Zone,
Tu-Cheng City, Taipei, Taiwan 23678
Tel: 886-2 2267 7986 / Fax: 886-2 2267 9876
E-Mail: [email protected]
Website: gianni.tw
Copyright 2008 Gianni industries, inc. All rights reserved.
DM-CA-PSB Ver. E Published on 2009.06.12