GE PROFILE PP972SM - Manual

For answers to your Monogram, ® GE Profile ™ or
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center ® service,
800.626.2000.
220596
Listed by
Underwriters
Laboratories
† Note: Check local codes for required breaker size
Important: Requires a 5" free area between
the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Refer to installation instructions. Requires a
15" minimum from cooktop to adjacent
overhead cabinets. Units are furnished with
a 48" flexible armored cable.
Note: 36" Ribbon cooktops are approved for use over GE 30" Single Wall
Ovens and Warming Drawers only. Refer to cooktop and wall oven/
warming drawer installation instructions packed with product for
current dimensional data. If installed with a GE Profile
™ Telescopic
Downdraft System, consult both the cooktop and downdraft installation
instructions packed with product before installing. Cooktop gas/electric
supply may need to be re-routed to install downdraft. The countertop
must be at least 26" deep with a flat surface area of 23-1/2" or more,
front to back. In addition, other clearances to the front edge of the
countertop must be considered, especially on raised bullnose countertops.
Consult cabinet and countertop manufacturer’s specs for flush mount
installation prior to install.
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
KW Rating
240V 8.9
208V 6.7
Breaker Size
240V 40 Amps †
208V 40 Amps †
3-1/4*
Cooktop
2-1/2**
Required
33-7/8
19-1/8
36-1/8
36_ss_cktp_install.eps
21
Electrical junction box 16" MIN.
below countertop
30" MIN. to
unprotected
cabinet
Cut should
not interfere
with cabinet
structure
at front
2" MIN.
clearance to
side wall
from cut-out
2" MIN.
clearance to
side wall
from cut-out
1-3/4" to
rear wall
13" MAX.
depth
* Depth of unit at conduit connection location (rear) is
6-1/2" on models PP980/950 and 4-5/8" on models
PP975/972/962/945/942/932/912, JP655/356/346.
**Raised bull nose countertops may require up to
3/8" additional clearance to prevent interference
with curved front.
15" MIN.
to cabinet
Specification Created 10/06
PP972SM
GE Profile ™ 36" Built-In CleanDesign Electric Cooktop
Dimensions and Installation Information (in inches)