Moisture selector, Using the warming drawer, On signal light – GE ZDK910 User Manual

Page 7: Control knob, Additional pans

Advertising
background image

Using the Warming Drawer

Electric Warming Drawer

ON signal
light

The ON signal light is located below the
ON/OFF

switch and glows when the ON/OFF

switch is in the ON position. It stays on until the
ON/OFF

switch is moved to the OFF position.

The ON signal light is visible through the light
viewer in the drawer front panel when the
drawer is closed. This is a reminder that the heat
is on.

PROOF

HI

MED

LO

Control
knob

The warming drawer controls are hidden with
the drawer shut. Open the drawer. The controls
are on the right side of the front frame.

To use the warming drawer, press the ON/OFF
switch to the ON position.

Slide the moisture selector control to the open
or closed setting. (See the Moisture Selector
section.)

Turn the control knob clockwise to the desired
setting.

PROOF

. . . 75–95°F.

LOW

. . . . . . 140–160°F.

MED

. . . . . . 160–195°F.

HIGH

. . . . 195–230°F.

Moist

Closed

Vent

Crisp

Open

Vent

Moisture
selector

The moisture selector is located on the inside
front of the drawer.

To keep foods moist,

slide the moisture selector

control away from the control knob. This closes
the vent and seals the moisture inside the
drawer. With the vent closed hot foods stay
moist and soft.

In this setting condensation may occur around
the inside edge of the drawer.

To keep foods crisp,

slide the moisture selector

control to the right towards the control knob.
This opens the vents and allows the moisture
to escape.

With the vents open, it is normal for moisture to
collect on surfaces above the warming drawer.

Additional
pans

An accessory pan kit JXPN1 is available from GE
at extra cost.

Five commercial pans with lids (4

deep)

• One large pan (14 quarts)
• Two medium pans (6 quarts each)
• Two small pans (3 quarts each)

7

Advertising
This manual is related to the following products: