Of the “appendix – Garmin GPSMAP 296 User Manual

Page 147

Advertising
background image

Check Beacon Wiring—the DGPS setting is enabled in the

Interface sub tab on the Main Menu but no DGPS device is

detected.

No Beacon Signal—DGPS receiver is attached, but not

transmitting RTCM data to GPS.

Tuning Beacon—the receiver is tuning manually to a DGPS

frequency.

Using Differential—the unit is receiving DGPS corrections.
Scanning for Beacon—the DGPS receiver is scanning for an

available frequency.

What is WAAS?

The Wide Area Augmentation System (WAAS) is an FAA-funded

project to improve the overall integrity of the GPS signal and

increase location accuracy for users in North America.
The system is made up of satellites and approximately 25 ground

reference stations located across the United States that monitor GPS

satellite data. Two master stations, located on either coast, collect

data from the reference stations and create a GPS data correction

message.

According to the FAA’s Web site, testing of WAAS in September

2002 confirmed an accuracy performance of 1–2 meters horizontal

and 2–3 meters vertical throughout the majority of the continental

United States and portions of Alaska.
WAAS is just one service provider that adheres to the MOPS

(Minimum Operational Performance Standard) for global Satellite

Based Augmentation Systems (SBAS). Eventually, there will

be several services of worldwide geostationary communication

satellites and ground reference stations.
All SBAS systems use the same receiver frequency; therefore, any

operational SBAS system should be capable of providing your GPS

unit with increased accuracy at any location in the world.
Currently, enabling WAAS on your Garmin GPSMAP 296 in regions

that are not supported by ground stations may not improve accuracy,

even when receiving signals from an SBAS satellite. In fact it can

degrade the accuracy to less than that provided by GPS satellites

alone. For this reason, when you enable WAAS on your Garmin

GPS receiver, the receiver automatically uses the method that

achieves the best accuracy. To enable WAAS, refer to

page 6

.

For more information, go to

http://gps.faa.gov/Programs/WAAS/waas.htm

.

GPSMAP 296 Pilot’s Guide

139

A

PPENDIX

>

L

EARNING

ABOUT

GPS

Advertising