Gateway 980 - Manual (Page 64)

59
Replacing the power supply
www.gateway.com
2
Unplug the power cord from the failed power supply.
3
While pressing the power supply’s lever release latch, pull the lever away
from the server.
4
Pull the power supply straight out of the server.
5
Slide the new power supply into the power supply bay as far as it will go,
then swing the lever up until it snaps into place.
6
Plug the power cord into the new power supply. The new power supply
is ready if the bottom green LED is on and the top LED is on or blinking.