Graco PM-1589AB - Manual (Page 16)

14
OPERATIONS and ADJUSTMENTS
(continued)
Changing Harness Strap Slots:
MUST use slots at or just above shoulders.
A Lift adjuster bar and pull harness straps
out of current slots.
B Change harness strap slots.
Make sure harness straps are threaded
through matching slot of seat pad and
car seat.
It may be necessary to remove seat pad
from top of car seat.
C Thread harness straps behind opening
in metal plate and adjuster bar (fig. f).
D Lift adjuster bar and thread straps over
adjuster bar, creating loop, and down
behind metal plate (fig. g).
E Pull each end of harness strap down
at least 2 inches (5 cm) below metal
plate (fig. h).
F Adjust harness straps to fit child (see ).
NOTE: Make sure straps are NOT twisted.
7
6
Changing Crotch Strap Slots:
MUST be in slot closest to but not under child.
A Turn car seat upside down, pry metal
rod loose and pull rod out of crotch strap
end (fig. i).
CAUTION: Be careful not to damage
webbing with screwdriver.
B Turn car seat upright and pull crotch strap
and buckle out.
C Change crotch strap slots.
Thread looped end of crotch strap through
slots in seat pad and shell (fig. j).
D Slide metal rod through loop in crotch
strap and press into car seat shell (fig. k).
NOTE: Use a hammer to tap rod if
necessary.