Washer connections for stationary model, Washer connections for stationary model , 12, Warning – GE WSLP1500 User Manual

Page 11

Advertising
background image

11

Cable Tie

Cable Tie

Cable Tie

Laundry Tub

Stand Pipe

WARNING:

Make sure the washer is unplugged.

Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog up
the water valve screens.

FLUSH WATER LINES

1

Installation Instructions

WASHER CONNECTIONS FOR STATIONARY MODEL WSLS1500

Connect the inlet hose ends to the HOT and COLD water
faucets tightly by hand, then tighten another

2

3

turn with

pliers. Turn the water on and check for leaks.

CONNECT TO WATER LINES

2

CAREFULLY MOVE THE WASHER TO
ITS FINAL LOCATION

3

Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place the hose in
a laundry tub or stand pipe and secure it with a cable
tie (not included).

NOTE: If the drain hose is placed in a stand pipe without
forming a U shape, a siphoning action could occur. There
must be an air gap around the drain hose. A snug hose
fit can also cause a siphoning action.

CONNECT DRAIN HOSE

4

PLUG THE POWER CORD INTO A
GROUNDED OUTLET

5

Insure proper ground
exists before use

Advertising
This manual is related to the following products: