Alcove or closet installation, Run the washer through a complete cycle, Read the rest of this owner’s manual – GE WSLP1500 User Manual

Page 12: Installation checklist

Advertising
background image

ALCOVE OR CLOSET INSTALLATION

12

60 sq. in.
(387.1 sq. cm)

60 sq. in.
(387.1 sq. cm)

Closet door

Installation Instructions

WASHER CONNECTIONS FOR STATIONARY MODEL WSLS1500

RUN THE WASHER THROUGH A
COMPLETE CYCLE

7

Check for water leaks and proper operation.

REMOVE THE PROTECTIVE FILM
COVERING THE CONTROL PANEL

8

It contains valuable and helpful information that will save
you time and money.

READ THE REST OF THIS OWNER’S
MANUAL

9

NOTE: If your washer does not operate, please review
the Before You Call For Service section.

If your washer is approved for installation in an alcove or
closet, there will be a label on the back of the machine
describing requirements.

Minimum clearances between washer and adjacent
walls or other surfaces are: 0" either side, 2" front,
3" rear.

Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc. is 96".

Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches open area for
washer only, or if the closet contains both a washer
and dryer, doors must contain at least 120 square
inches of open area equally distributed.

NOTE: The clearances stated on this label are minimums.
Consideration must be given to providing adequate
clearances for installation and servicing.

INSTALLATION CHECKLIST

6

Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line

or washer.

Advertising
This manual is related to the following products: