Global Machinery Company REDEYE DB305SMS - Manual (Page 17)

17
Cross-cutting (without slide action)
When cutting a narrow piece of wood it is not necessary to
use the slide mechanism. In these cases ensure that the
slide lock (29) is screwed down to prevent the saw arm
from sliding.
A crosscut is made by cutting
across the grain of the
workpiece. A 90º crosscut is
made with the mitre table
set at 0º (fig. q). Mitre
crosscuts are made with the
table set at some angle other
than zero.
1. Pull on the release knob
(6) and lift the saw arm (5) to its full height.
2. Loosen the mitre lock (25).
3. Rotate the mitre table (21) until the pointer aligns with
the desired angle.
4. Retighten the mitre lock (25).
WARNING. Be sure to tighten the mitre lock before making
a cut. Failure to do so could result in the table moving
during the cut and cause serious personal injury.
5. Place the workpiece flat on the table with one edge
securely against the fence (19). If the board is warped,
place the convex side against the fence. If the concave
side is placed against the fence, the board could break
and jam the blade.
6. When cutting long pieces of timber, support the opposite
end of the timber with the side support bars (37), a
roller stand or a work surface that is level with the saw
table.
7. Use the clamp assembly (10) to secure the workpiece
wherever possible.
8. It is possible to remove
the clamp assembly (10)
by loosening the clamp
assembly lock (11) and
moving it to the other side
of the table. Make sure
the clamp assembly lock
is tight before using the
clamp (fig. r).
9. Before turning on the saw,
perform a dry run of the cutting operation to check that
there are no problems.
10. Hold the operating handle (7) firmly and squeeze
the switch trigger (24). Allow the blade to reach
maximum speed.
11. Press the release latch (36) (fig. s) and slowly lower
the blade into and
through the workpiece.
12. Release the switch trigger
(24) and allow the saw
blade to stop rotating
before raising the blade
out of the workpiece.
Wait until the blade stops
before removing the
workpiece.
q
r
s