Gemini CDX-1250 - Manual (Page 4)

Congratulations on purchasing the Gemini CDX-1250 CD Player.
This state of the art 2U professional CD player is backed by a 1 year
warranty*. Prior to use, we suggest that you carefully read all the instructions.
- Audio CD, & CD-R, compatible
- Anti-shock using RAM buffer memory
- XLR balanced Output
- 1/8” (3.5mm) Mp3 player input
- Output volume control
- 2 Selectable Jog modes Pitch Bend/Search
- Instant-start & cue with preview
- Single & continuous play modes
- One seamless loop with reloop
- Pitch bend via jog wheel or buttons +/- 16%
- Three mode time selection
- Frame accurate search
- Large blue backlit LCD display
- Rubber jog wheels with finger grips
- Variable pitch control with a +/- 12% range
Laser Diode Properties
Material: Ga - Al - As
Wavelength: 755 - 815 nm (25° C)
Laser Output: Continuous Wave, max. 0.5 mW
INTRODUCTION:
4
FEATURES:
SAFETY SPECIFICATIONS:
PRECAUTIONS:
CONNECTIONS:
1
VOLTAGE SELECTION SWITCH Before plugging the CDX-1250 into
any wall outlet, make sure that the VOLTAGE SELECTION SWITCH is
set to the proper voltage.
To change this selection unscrew the hard plastic protective top with a
Phillips head screw driver. Then use a flat head screw driver to move
the switch to the proper selection (115V or 230V) .
Do not force or twist the switch. Excessive force may cause damage, if
the switch does not move smoothly, contact a qualified technician.
POWER After you have properly set the VOLTAGE LINE SELECTOR
SWITCH you may plug in the power cord of the CDX-1250.
LINE OUTPUT JACKS Plug one end of the included RCA cable into
LINE OUTPUT JACKS on the rear panel. Plug the other end of the
RCA connectors into any available line input jacks on your mixer.
If you are connecting the CDX-1250 through a receiver, you can
plug the RCA connectors into the CD or AUX INPUT JACKS on your
receiver. If there are no CD or AUX INPUTS use any line level
(not phono) inputs.
There is also a BALANCED pair of XLR outputs for pro installations,
both RCA and XLR can be used at the same time.
3
4
FUNCTIONS:
POWER: Once you have connected all your cables and made sure
that the VOLTAGE SELECTION SWITCH is set correctly, you can turn
the CDX-1250 on by pressing the POWER button, pressing the
CDX-1250’s POWER button a second time will turn off the unit.
DISC TRAY: The DISC TRAY is where the CD is held during loading,
unloading and playback, and holds both 12 cm and 8cm CD’s.
(DO NOT FORCE THE CD TRAY TO CLOSE EXCESSIVE FORCE WILL
DAMAGE THE CD MECHANISM, USE THE OPEN AND CLOSE BUT-
TONS)
EJECT BUTTON: Pressing the EJECT BUTTON will open or close the
DISC TRAY, unless the CDX-1250 is in play mode, then you must first
stop the side you wich to eject.
JOG WHEEL : In SEARCH MODE the JOG WHEEL can be used to
search forward or bacwards in the music track, as well as for fine
adjustments to a CUE point in PAUSE mode. In PITCH BEND mode
the JOG WHEEL will function the same as the PITCH BEND allowing
you to speed up (FORWARD) or slow down (REWIND) the music
clockwise bieng (FORWARD) and counter clockwise being (REWIND).
JOG MODE BUTTON: When the JOG MODE BUTTON is illuminated
it indicates the the JOG WHEEL is in SEARCH MODE, and when not
illuminated it indicates that the JOG WHEEL is in PITCH BEND
MODE.
DISPLAY: The DISPLAY shows the track number, pitch value, pitch
bend, single, continue (for continuous play), play/pause modes, fast
forward/reverse modes, loop mode, reloop mode, PGM, repeat
modes, the playback display bar, and three diffirent time displays.
These times displays are TIME ELAPSED on the track, TIME REMAIN-
ING on the disc and and TIME REMAINING on the track. Time is
measured in minutes, seconds and frames.
PGM: Allows you to create a set playlist. To program a set list into
the CDX-1250 memory, begin by stopping the unit from play and
pressing PGM to begin the set list. Select a track by using the track
selection button to scan to the first track to be placed in the set list.
When you have selected the proper track press PGM and the
CDX-1250 will be ready to set your next selection. Repeat the pre-
vious steps until you have completed your playlist, then press play to
begin the set list.
REPEAT: Press the repeat button once to engage 1 or repeat the
selected track. Press REPEAT again to engage ALL setting wich will
repeat all the tracks on the CD. Press REPEAT again to disengage
the repeat function
5
6
7
8
9
10
11
CDX-1250
1. Do not use this CD player at temperatures below 41°F/5°C or
higher than 95°F/35°C.
2. The apparatus should not be exposed to dripping or splashing,
and no objects filled with liquids such as vases should be
placed on the apparatus.
3. Place the unit in a clean and dry location.
4. Do not place the unit in an unstable location.
5. When disconnecting the power cord from the AC outlet,
always grasp it by the plug. Never pull the power cord.
6. To prevent electric shock, do not remove the cover or the bottom screws.
7. There are NO USER SERVICEABLE PARTS INSIDE. Please
refer to a qualified technician.
8. Do not use chemical solvents to clean the unit.
9. Keep the laser pickup clean by keeping the tray closed.
10. Keep this manual in a safe place for future reference.
IN THE USA ~ IF YOU EXPERIENCE PROBLEMS WITH THIS UNIT CALL GEMINI CUSTOMER SERVICE AT:
1 (732) 346-0061. DO NOT ATTEMPT TO RETURN THISE EQUIPMENT TO YOUR DEALER.
2