GE JRS06 - Manual (Page 11)

Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
GEAppliances.com
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds until
the CLEAR/OFF pad is touched. This continuous
6 second beep may be canceled.
To cancel the 6 second beep:
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the BROIL HI/LO pad. The
display shows CON BEEP (continuous
beep). Touch the BROIL HI/LO pad
again. The display shows BEEP.
(This cancels the one beep
every 6 seconds.)
Touch the START pad.
NOTE: This feature is not available for the
lower oven.
12 Hour, 24 Hour or Clock Black-Out
Your control is set to use a 12 hour clock.
If you would prefer to have a 24 hour
military time clock or black-out the clock
display, follow the steps below.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the TIMER/CLOCK pad once.
The display will show 12 hr. If this
is the choice you want touch the
START pad.
Touch the TIMER/CLOCK pad again
to change to the 24 hour military
time clock. The display will show
24 hr. If this is the choice you want
touch the START pad.
Touch the TIMER/CLOCK pad again
to black-out the clock display.
The display will show OFF.
If this is the choice you want
touch the START pad.
NOTE: If the clock is in the black-out mode you
will not be able to use the Delay Start function.
Cook and Hold
Your new control has a cook and hold feature that
keeps cooked foods warm for up to 3 hours after
Timed Baking or Roasting is finished.
NOTE: This feature can only be programmed to
work with Timed Baking or Roasting. (See the
Using the timed baking and roasting features
section.) After Timed Baking or Roasting has
automatically stopped, the programmed Cook
and Hold will automatically start.
To activate this feature for use after
Timed Baking or Roasting, follow the
steps below.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the COOKING TIME pad. The
display will show Hld OFF.
Touch the COOKING TIME pad again
to activate the feature. The display
will show Hld ON.
Touch the START pad to activate the
cook and hold feature and leave the
control set in this special features
mode.
NOTE: This feature is not available for the
lower oven.
Changing the Speed of the + or – Pads
As you use the + or – pad when setting a time or
temperature, you may notice the display changes
slowly. This special feature allows you to change
the speed. To set the speed you prefer, follow the
steps below.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the + pad. The display will
show you a set speed between
1 and 5.
Touch the + pad to increase the
speed up to the number 5.
Touch the – pad to decrease the
speed down to the number 1.
Touch START to activate the setting
and leave the control set in this
special features mode.
11