Generac Power Systems OG 2697 - Manual (Page 4)

3
NFPA 0, LIFE SAFETY CODE
NFPA 0, STANDARD FOR
EMERGENCY AND STANDBY
POWER SYSTEMS
NFPA 0, STANDARD TYPES OF
BUILDING CONSTRUCTION
NOTE:
It is essential to use the latest version of any
standard to ensure that the generator and its
accessories comply with all the applicable
standards and local codes.
Other Published Standards
In addition to NFPA standards, the
following information pertaining to the
installation and use of standby electric
systems is available:
Article X, NATIONAL BUILDING CODE,
available from the American Insurance
Association, 85 John Street, New York,
NY 0038.
AGRICULTURAL WIRING
HANDBOOK, obtainable from the Food
and Energy Council, 909 University
Avenue, Columbia, MO 650.
ASAE EP-364., INSTALLATION
AND MAINTENANCE OF FARM
STANDBY ELECTRIC POWER,
available from the American Society of
Agricultural Engineers, 950 Niles Road,
St. Joseph, MI 49085.
A5., AMERICAN NATIONAL
STANDARDS FOR CHIMNEYS,
FIREPLACES AND VENTING
SYSTEMS, available from the American
National Standards Institute, 430
Broadway, New York, NY 008.
The installer must comply with all
applicable state and local codes.
Grounding the Generator
A grounding lug is provided on the generator
mounting base for the purpose of grounding the
frame and the external electrically conductive
parts of this equipment to an approved earth
ground and/or grounding rods where required
by the National Electrical Code. Grounding
procedures must meet local regulations.
Battery Installation
Standby generators installed with automatic
transfer switches will crank and start
automatically when NORMAL (UTILITY)
source voltage is removed or is below an
acceptable preset level. To prevent such
automatic start-up and possible injury to
personnel, do not connect battery cables
until certain that normal source voltage at the
transfer switch is correct and the system is
ready to be placed into operation.
Storage batteries give off explosive hydrogen
gas. This gas can form an explosive mixture
around the battery for several hours after
charging. The slightest spark can ignite the
gas and cause an explosion. Such an
explosion can shatter the battery and cause
blindness or other injury. Any area that houses
a storage battery must be properly ventilated.
Do not allow smoking, open flame, sparks or
any spark producing tools or equipment near
the battery.
Battery electrolyte fluid is an extremely
caustic sulfuric acid solution that can cause
severe burns. Do not permit fluid to contact
eyes, skin, clothing, painted surfaces, etc.
Wear protective goggles, protective clothing
and gloves when handling a battery. If fluid
is spilled, flush the affected area immediately
with clear water.
Do not dispose of the battery in a fire. The
battery is capable of exploding.