Morphy Richards 43541 User Manual

Switching on, When to change your brita maxtra cartridge, Hints and tips cleaning and maintenance

Advertising
background image

Change display G:

Every week, one bar will

disappear to show the

remaining cartridge life. After

four weeks, all four bars will

disappear. This, and a flashing

arrow, indicate that the

cartridge should now be

changed. Insert a new

cartridge according to the

instructions, and reactivate the

Memo as described above.

REPLACING THE

BRITA MEMO

BRITA Memo - the electronic

cartridge exchange reminder

has a life of approximately 5

years. At the end of the

Memo’s life, please remember

that it is an electronic device

and to dispose of the Memo

according to all applicable

provisions and regulations. To

remove the exhausted Memo,

place a screwdriver in the notch

next to the Memo and push it

out. Please note that Memo

should not be removed for any

other reason than to dispose of

it.

More information on the use of

BRITA filter cartridges and the

BRITA Memo can be found in

the BRITA information guide

supplied with the kettle.

Telephone our replacement

parts helpline for your new

BRITA Memo.

SWITCHING ON

You do not need to wait until

the water has filtered through

before boiling. Your Morphy

Richards filter kettle will boil

and filter at the same time,

giving you boiled BRITA filtered

water quickly.

Boil only as much water as you

need, as this saves electricity.

1

Place the filter kettle on the

base unit, ensuring the kettle

locates on to the 360°

connector.

The 360° connector allows the

kettle to be located at any

position - ideal for left and right

handed users and convenient

positioning on a worktop.

2

Plug in and switch on at the

wall socket.

3

Switch the kettle on. The kettle

will illuminate internally.

4

When the water boils, the filter

kettle will switch off

automatically.

If you are using the kettle for

the first time, discard the water

and repeat once more.

To re-boil, switch to ON again.

If the kettle has just switched

off, wait a minute or so before

switching it back on again.

If you do not put in enough

water, or switch on the filter

kettle when it is empty, the

safety cut-out will switch off the

power automatically. If this

happens, refill and wait a few

minutes for the element to cool,

then use as normal.

5

Lift the filter kettle from the

base unit by the handle,

ensuring you hold the kettle

level.

WARNING: Unless the

cartridge holder is fitted

correctly, the filter kettle

may not operate correctly

and the lid may not close

and lock securely.

WHEN TO

CHANGE

YOUR BRITA

MAXTRA

CARTRIDGE

This depends on water quality

and the improvement required.

We recommend that you

change your cartridge after 4

weeks.

The electronic reminder on your

Morphy Richards water filter

kettle will remind you when to

change your cartridge.

BRITA filter cartridges conform

to the highest quality

standards. Raw materials and

final products are subject to

stringent internal and external

controls. BRITA filter cartridges

are steam sterilised. An

independent institute certifies

the food grade quality of BRITA

water filters and cartridges.

Great taste, less waste:

The BRITA MAXTRA cartridge

is 100% recyclable. Please

contact BRITA customer care

team for advice on recycling

schemes on

0844 742 4800, or visit

www.brita.co.uk/recycle H.

HINTS AND TIPS
Cleaning and

maintenance

WARNING: Always

disconnect the plug from

the mains and allow the

appliance to cool before

cleaning.

Wipe the outside with a damp

cloth.

IMPORTANT: Do not use

abrasive cleaners on the

outside of the appliance,

as they may scratch the

surface.

55

UUKK HHeellpplliinnee 00884444 887711 00995544

RReeppllaacceem

meenntt PPaarrttss 00884444 887733 00772200

IIrreellaanndd HHeellpplliinnee 11880000 440099 111199

H

G

43541 Rev1 29/4/08 16:27 Page 1

Advertising