Murray 425604x18A - Manual (Page 11)

(A)
1001054
(B)
17x47
ASSEMBLY
11 F–030753L
HOW TO INSTALL THE SEAT
Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
1. Carefully remove the
plastic bag from the seat.
2. Align the holes in the seat
hinge to the holes in the
seat (Figure 1). Fasten
the seat to the seat hinge
with the fasteners as
shown.
3. Check the operating posi-
tion of the seat. If the seat
needs to be adjusted,
loosen the two wing
bolts. Slide the seat for-
ward or backward along
the seat adjusting holes
as shown. Tighten the
wing bolts (A).
Figure 1
Seat
Seat
Adjusting
Hole
Seat Hinge
A
B
HOW TO ASSEMBLE THE STEERING WHEEL
Use the fasteners shown below to install the steering wheel. The
fasteners are shown at full size.
(A)
25x3
(C)
17x146
1. Make sure the front wheels point forward.
2. Slide the cover, if equipped, over the steering post (Figure 2).
NOTE: The cover is an optional accessory and is not re-
quired on all models.
3. Slide the steering wheel onto the steering post.
4. Apply firm pressure to center of the steering wheel with the
palm of your hand until you hear a clicking noise. To check for
proper locking of the steering wheel to the steering post, pull
upward on steering wheel.
5. Use the fasteners shown above to secure the steering wheel.
The fasteners are shown at full size. Tighten the screw. DO
NOT over tighten.
6. Remove adhesive backing from hub cover (found in parts bag)
and place hub cover over hub.
Steering Wheel
Cover
Hub Cover
Figure 2
A
C
Steering Post
HOW TO ASSEMBLE THE GAUGE WHEELS
Use the fasteners shown below to install the gauge wheels.
(A)
31x11
(B)
17x91
1. Attach the gauge wheels to the axle bolts with the fasteners.
NOTE: The axle bolt is mounted in the LOW position. To change
the position to a higher cutting position, see “How To Adjust
The Gauge Wheels” in the Maintenance section.
Gauge Wheel
Figure 3
Axle Bolt
A
B