MITSUBISHI ELECTRIC LVP-X30U - Manual (Page 31)

E – 29
ENGLISH
⇔ ⇔
Using the Power Saving Function
When there is no signal input for a period of 5 min. or
more, the power is automatically turned off and standby
status is activated.
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor
$
/
%
buttons to select “SETUP”.
2
When SETUP menu is displayed, use the
cursor
{
/
}
keys to select “AUTO
POWER OFF”.
3
Use the cursor
$
/
%
keys to set Power
Saving to ON or OFF.
To close the menu
Press the CANCEL button.
Auto Source Settings
Automatically Searching The Input Signal
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor
$
/
%
keys to select “SETUP”.
2
Use the cursor
{
/
}
keys to select
“AUTO SOURCE”, then use the cursor
$
/
%
keys to set ON or OFF.
ON: All input signals are searched.
OFF: Remote control VIDEO button:
Video and S-video are searched.
Remote control RGB button:
RGB and YCbCr signals are searched.
Main unit SOURCE button:
All input signals are searched individually.
Selecting a Projection Type
If the projection type is not correctly set in accordance with the
installation conditions, images may be projected reversed, verti-
cally, or horizontally.
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor
$
/
%
keys to select “SETUP”.
2
When SETUP menu is displayed, use the
cursor
{
/
}
keys to select “PROJEC-
TION”, then press the ENTER button.
3
Use the cursor
{
/
}
keys to select a
projection type in accordance with the
set conditions.
The setting items will change as shown below
each time a key is pressed.
Normal
⇔
Reversed vertically+horizontally
Reversed vertically
⇔
Reversed horizontally