Motorola VT1000 - Manual (Page 18)

12
Installation With A Single Computer
To connect your Motorola voice terminal as shown in “ Sample Configuration Without A
Home Network ” on page 2:
1 Be sure the Motorola voice terminal is unplugged. Be sure power is off to your
broadband modem (cable or DSL) and computer.
2 Connect one end of an Ethernet cable (RJ-45) to the Ethernet connector on your
broadband modem. Connect the other end of this Ethernet cable to the WAN
connector on the Motorola voice terminal.
3 Connect one end of another Ethernet cable to the PC connector on the Motorola
voice terminal. Connect the other end of this Ethernet cable to the Ethernet
connector on the computer.
4 Connect a telephone to the LINE 1 connector using a phone wire (RJ-11). For a VT1005
or VT1005v only, you can connect a second telephone to the LINE 2 connector.
5 Power on the broadband modem, following the instructions provided with your
modem. Wait about two minutes for it to start up.
6 Plug the AC power adapter to the POWER connector on your Motorola voice
terminal and the electrical outlet. This turns your Motorola voice terminal on. You do
not need to unplug it when not in use.
Wait about two minutes for the Motorola voice terminal to start up. The POWER light
blinks as described in “
Front Panel ” on page 7.
Motorola voice
terminal
Broadband
Modem
Computer
WAN
PC
Ethernet port
Ethernet port
Phone
LINE 1