Metra Electronics 95-7326 - Manual (Page 5)

3
95-7326 KIT ASSEMBLY
B
C
CUT OUT BAR
CUT HERE
A
STACKED ISO MOUNT UNITS PROVISION
Snap the Double DIN brackets to the
inside edge of the Double DIN trim
plate. (Figure B) 2
Slide the stacked ISO units into the
bracket/trim plate assembly and
secure the units to the assembly using
the screws supplied with the units.
(Figure C) 3
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Cut and remove the bar in the factory
radio trim panel. (Figure A) 1
TIP: The smoother the cut, the better
the 95-7326 will look in the dash panel.