Mitel 5304 - Manual (Page 51)

Mitel ® 5304 IP Phone User Guide – Issue 2, June 2010 Page 37
Call Features
Ending a Conference and Placing all Parties on Hold
You can end a conference and place all conference parties on Individual Hold, allowing you to
toggle between the held parties and speak to one party at a time.
To end a conference and place all parties on Individual Hold:
1. Press the Special button, and then dial 5.
2. Press the Hold button. CONFERENCE PARTIES ON HOLD appears.
To toggle between the held callers:
Press the Hold button twice for internal parties or the applicable Call button for external
parties.
Using Record-A-Call
You can use Record-A-Call to record an ongoing call as a mailbox message. 1 You can then
retrieve the message from your voice mailbox. The Record-A-Call feature stays active after the
other party hangs up, so you can add your own message to the recorded call.
To use Record-A-Call:
1. While on a call, press the Special button, and then dial 385. REQUESTING RECORD-
A-CALL appears.
2. Enter the voice mailbox number where you want the recording to be saved.
RECORD-A-CALL IN PROGRESS appears, and both you and the calling party hear a
confirmation tone (if enabled).
To stop Record-A-Call:
Do one of the following:
• Press the Special button, and then dial 385.
• Hang up.
1. This feature may or may not be enabled for your system.
NOTE
Record-A-Call is not supported on peer-to-peer (P2P) calls. Contact your system
administrator for more information.
NOTE
If your system administrator assigns the Record-a-Call voice mailbox
destination, you do not need to enter the voice mailbox number.