McCulloch MS4016PAVCC - Manual (Page 7)

6
3 - ASSEMBLY INSTRUCTIONS
3-1. TOOLS FOR ASSEMBLY
You will need these tools to assemble your chain saw:
1.
Combination wrench-screwdriver (contained in your
user’s kit or in lid of carry case).
2. Heavy duty work gloves (user supplied).
3-2. ASSEMBLY REQUIREMENTS
Your new chain saw will require adjustment of chain, filling
the fuel tank with correct fuel mixture and filling the oil tank
with lubricating oil before the unit is ready for operation.
WARNING
DO NOT start saw engine until unit is properly prepared.
Read the entire user manual before attempting to operate
your unit. Pay particular attention to all safety precautions.
Your user manual is both a reference guide and handbook
provided to furnish you with general information to assem-
ble, operate and maintain your saw.
3-3. GUIDE BAR / SAW CHAIN / CLUTCH
COVER INSTALLATION
WARNING
Always wear protective gloves when handling chain.
TO INSTALL GUIDE BAR:
CAUTION
To ensure the bar and chain receive oil, ONLY USE THE
ORIGINAL STYLE BAR with the oil passage hole (A) as
illustrated below (Figure 3-3A).
1.
Make sure the CHAIN BRAKE
®
lever is pulled back
into the DISENGAGED position (Figure 3-3B)
2. Remove the bar retaining nuts (B). Remove clutch
cover (C) by pulling straight out, some force may be
required. (Figure 3-3C)
NOTE: Discard the two plastic washers. They are only
used for shipping the chain saw.
3. Using a screwdriver located the wrench supplied in
the user’s kit or in the upper half of the carrying case.
Turn the adjustment screw (D) COUNTERCLOCK-
WISE until the TANG (E) (projecting prong) is to the
end of its travel (Figure 3-3D).
4. Place the slotted end of the guide bar over the bar bolt
(F). Slide guide bar behind clutch drum (G) until the
guide bar stops (Figure 3-3E).
A
3-3A
3-3B
3-3C
C
B
3-3D
3-3E
E
G
F
D