Multiquip Mayco Miratron Wireless Remote Control Radio C30HDG - Manual (Page 13)

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 13
TROUBLESHOOTING
Troubleshooting Table 2.
Symptom Possible Problem Solution
Transmitter does not
function at all LED status indicator not
fl ashing.
LED indicator not lit when
power ON/OFF switch is
pressed.
Turn transmitter power
switch ON.
Weak dead battery, replace
batteries.
Check orientation of
batteries.
Make sure transmitter has
be matched (paired) to
receiver.
Receiver is not powered
up.
Transmitter range is poor LED indicator not lit when
power ON/OFF switch is
pressed
LED indicator lit when
switch is pressed
Weak dead battery, replace
batteries.
Check receiver antenna
Maintain line-of-sight
Avoid obstructions
Check for interference
Heavy rain reduces range
Transmitter works (RX LED
in receiver comes on) but
outputs do not operate Check wiring. Make sure output wires are
not shorted to Ground
Verify load is wired
correctly.