Makita GD0810C - Manual (Page 8)

8
OPERATION
Turn the tool on without the wheel point making any contact
with the workpiece and wait until the wheel point attains full
speed. Then apply the wheel point to the workpiece gently.
To obtain a good finish, move the tool in the leftward direction
slowly.
CAUTION:
• Apply light pressure on the tool. Excessive pressure on
the tool will only cause a poor finish and overloading of
the motor.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY, repairs, car-
bon brush inspection and replacement, any other mainte-
nance or adjustment should be performed by Makita
Authorized or Factory Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita service center.
• Wheel points
• Collet cone set (1/4", 1/8")
• Wrench 13
• Wrench 19
• Side handle set
003497