MTD 614E - Manual (Page 17)

17
NOTE: Make certain to check for correct adjustment
of the shift rod as instructed in the Final Adjustments
section before operating the snow thrower.
Drive Wheels
• The wheels may be adjusted for two different
methods of operation. Follow the steps below for
adjustment. See Figure 22.
Figure 22
One Wheel Driving
• On the right side of the unit, place click pin in the
outside axle hole only. Do not place pin through
wheel hub.This position gives power drive to the left
wheel only, making the unit easier to maneuver.
Both Wheels Driving
• Rotate wheel assembly to align hole in the hub with
the inner hole on the axle shaft. Insert click pin in
the hole. Outer axle shaft hole should be visible.
IMPORTANT: NEVER operate the snow thrower with the
click pin inserted through both the RIM and the
OUTSIDE HOLE in the axle. Doing so can result in
serious damage to the drive system.
SECTION 7: MAINTAINING YOUR SNOW THROWER
WARNING: Before lubricating, repair-
ing, or inspecting, disengage all clutch
levers and stop engine. Wait until all mov-
ing parts have come to a complete stop.
Disconnect spark plug wire and ground it
against the engine to prevent unintended
starting.
Lubrication
Engine
Refer to the separate engine manual packed with your
unit for all engine lubrication instructions.
WARNING: If any adjustments need to
be made to the engine while the engine is
running (e.g. carburetor), keep clear of all
moving parts. Be careful of muffler, engine
and other surrounding heated surfaces.
Gear Shaft
• Lubricate the gear shaft with a good all-weather
multi-purpose light grease at least once a season or
after every 25 hours of operation.
IMPORTANT: Keep all grease and oil off the friction
wheel and drive plate.
Wheels
• Oil or spray lubricant into bearings at wheels at
least once a season. Pull click pin, remove wheels,
clean and coat axles with a multipurpose
automotive grease. See Figure 23.
Figure 23
Chute Directional Control
• The worm gear on the chute directional control
should be greased with multipurpose automotive
grease.
Inside Hole
In Axle
Click Pin In
Outside Hole
Click Pin
Axle