Michelin Navigation - Manual (Page 83)

•
To perform a soft reset, use the stylus to press the "reset" point on the back of your
ViaMichelin Navigation X-930 device.
•
Soft reset closes the application and restarts ViaMichelin Navigation.
Comment:
• Only procedures running at the time of the reset may be lost (e.g. the current route).
10.3.2. Hard reset
•
Hard reset restores your product to its initial conditions. After this operation, you will
need to reinstall the software.
•
It is a two-step process:
- Simultaneously hold down the volume reduce button, the on/off button and the
"reset" button (using the stylus) for a few seconds to switch off the device.
- Simultaneously hold down the volume increase button, the on/off button and the
"reset" button (using the stylus) to restart the device.
Comment:
• Before performing a hard reset, we advise you to remove the SD card. Reinstall it after the
hard reset.
• The saved addresses, the POIs installed with POI Manager and the destinations history are
retained. The installation settings (languages, speed limits, time, etc.) are deleted.
• To perform a hard reset, disconnect the ViaMichelin Navigation X-930 from the household
power or the cigar lighter plug.
10.4. Practical information
•
PC requirements:
- PC with 256 MB RAM or more
- Minimum 200 MHz Pentium processor
- DVD-ROM drive
- Microsoft Windows 2000 or XP
- Hard disk capacity required: 1.5 GB
•
Copyrights:
•
Software & cartography © ViaMichelin 2006. MICHELIN, Tire Man Device trademarks
are used under license from Michelin North America.
Digital Data © NAVTEQ 2005.
•
For other copyright information, click "Settings", "General" and "About" on the software
79