Merco Savory RT-2VSE - Manual (Page 5)

RT-2VSE/VSHO Service Manual 5
M – FRONT & REAR SHAFT BEARINGS
Figure 8
1. Remove outer case and conveyor chain.
2. To remove front shaft bearings: first, remove the
bearing retainers on both sides of the unit.
3. With retainers removed, slide bearing out (with
shaft, if necessary). Note proper location of the
spacer washers on the front bearing retainer
studs.
4. Replace bearings (and front shaft, if necessary).
5. To remove rear shaft bearings: remove drive
chain and conveyor shaft sprocket.
6. Remove bearing retainer brackets at both sides
of unit and slide bearings out. Shaft can be
replaced at this time, if needed. Note proper
orientation of hex head spacers.
7. Replace bearings (and rear shaft, if necessary),
shaft sprockets and drive chain.
8. Replace conveyor chain.