Multi-Link ML-001 - Manual (Page 25)

– 23 –
ADVANCED PROGRAMMING
To enable alert zone feature, follow the instructions below.
1
2
3
4
Enter Program-
ming mode Enter master
password to
programming mode 3 beeps for valid
password. 1 long beep
for invalid password.
Refer to the
diagram below to
select the
appropriate
setting.
[PROG]
when
finished. Terminate
programming
mode. PROG LED will be
off.
[8]
If alert zone is selected,
that zone LED will be on.
If it is not selected, the
LED will flash. You are
allow to make multiple
changes before terminat-
ing programming mode.
After [8] is entered,
some zone LEDs will
flash or stay on. This
indicates whether alert
zone is selected. Select Alert
Zone.
Select which
zone you
would like to
select as Alert
Zone. Disable
Alert Zone:
[1] to [5]
Enable
Alert Zone:
[6] to [0].
[PROG]
[MPIN]
Zone 1
DISABLE
ALERT ZONE
Button [1]
ENABLE
ALERT ZONE
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
This row :
Buttons to
Disable Alert Zone
Zone LED : Flash
This row :
Buttons to
Enable Alert Zone
Zone LED : ON
Step Keys Function Description Note
®
– 34 –
OPERATION
System Failure
Control Panel constantly monitors itself and its sensors. If there are any trouble
conditions, the control panel will advise the user. These trouble conditions include:
- Phone Line Failure
- Sensor Failure (loss of supervisory signal)
- Low Battery – Control Panel
- Low Battery – Sensors
Phone Line Failure
When the phone line is disconnected or malfunctions, the control panel will
instantly notify the user by:
1. Both Power [PWR] and Program [PROG] LEDs will flash together;
2. Voice announcement “Phone Line Failure” will be played.
When phone line failure occurs, please check the phone line connection, ensure
the phone line is plugged into both the control panel and the wall socket securely.
You should also check the phone line with a normal telephone to determine if it
can dial out to a phone number. If it cannot dial out, that indicates the phone line
is not in service, you should contact your local phone company.
Panic
Pressing the panic button on the control
panel or keychain remote will cause the
siren to sound and outgoing calls will
be made to the preprogrammed phone
numbers, “System Panic” will also be
announced. This can be used in any
emergency situation.
To stop the siren and disarm the system, user can enter a valid password, or
press the disarm button on the keychain remote. This will terminate the siren
and the control panel from calling the rest of the emergency phone numbers.
PANIC
ARM
DISARM
AUX
- Control other Skylink receiver
such as Garage Door Receiver
OR