Muratec IF-200 - Manual (Page 32)

Appendix B
31
RX packets number of reception
attempts
TX errors number of transmission
errors
RX errors number of reception errors
CRC errors source of reception errors
RUNT errs source of reception errors
DATA errs source of reception errors
OOW errors source of reception errors
JABBER err source of reception errors
Collisions source of reception errors
Underruns source of transmission
errors
RX misses source of reception errors
7.5. Update Firmware
If the IF-200 has received a firmware update, the user must go to the Advanced
Settings menu, Update Firmware option and accept (Yes) or discard (No) the received
update.
Alternatively, the user may configure the IF-200 to automatically accept and apply
firmware updates. To enable this feature, go to SETUP->Advanced Settings->Expert
Setting->Auto Apply Firmware and select YES.
NOTE: Firmware updates are received as special email messages.
7.6. Factory Defaults
Factory Defaults deletes all of the settings you entered and resets the IF-200 back to
the factory installed defaults. All ISP and mailbox information is lost.
To set the IF-200 back to the factory installed defaults, press SETUP from the Main
screen. Scroll to Advanced Settings and press EDIT. Scroll to Factory Defaults and
press EDIT.
WARNING
Once deleted, there is no way to recover the settings.